Roller Shutter with Electric Drive
Roller shutter, double-skinned, insulated, made of coated steel profiles, galvanized
consoles. Resistance to wind load in accordance with DIN 1055 T4. With header
seal and prime coated winding shaft.
Make: Teckentrup or equivalent.
Roller shutter ThermoTeck, steel, double-skinned
Direct mount drive 400 V (three-phase voltage), IP54,
emergency crank handle, integrated anti-drop device,
TÜV tested, maintenance-free.
CS 310 in the basic version, control voltage 24 V (safety low voltage), degree
of protection IP 65, "door closed" in deadman mode (permanent pressure),
with push buttons "open-stop-closed", fully wired ready for use and with CEE
Behind the opening, on concrete, all fastening
elements - suitable for the structure material - are supplied.
Ordering dimensions: _____mm wide and _____mm high
Wall and header thickness (concrete ___mm / masonry ___mm),
headroom ___mm, sideroom right-hand ___mm, left-hand ___mm.
Width: 1000 – 12000 mm
Height: 1000 – 12000 mm
up to 18000 mm door width on request.
( ) Permanent side part with integrated door
( ) Pivoted side part with integrated door
Roller box made of:
( ) Galvanized sheet steel
( ) Natural aluminium
( ) Other versions on request
Sloping bottom profile, aligned to the floor.
Side or roof installation
* ( ) please mark
Teckentrup GmbH & Co. KG
D-33415 Verl - Sürenheide
Tel.: +49 (0) 52 46/5 04-0
Fax: +49 (0) 52 46/5 04-230